
How to send and receive Unit0 tokens using Enkrypt
Step 1. Go to the Enkrypt website and click the Download button.
You will be redirected to your browser’s extension store. Click Install.

Step 2. After the Enkrypt extension is installed, you will be redirected to the wallet creation page. Click “Create a new wallet” to proceed.

Step 3. You will be asked to come up with a password for your wallet. Make sure it’s a strong one by using numbers and special symbols.

Tep 4. Next, confirm your password by typing it once more.

Step 5. After your password is set, you will see your secret recovery phrase consisting of 12 random words. Write them down. This is important because you can’t restore access to your wallet without the recovery phrase.

Step 6. In the next window, pick the words from your secret recovery phrase to confirm it.

Step 7. Now you can use your Enkrypt wallet. Find Enkrypt in your browser’s extensions and open it.


Step 8. To start using Enkrypt, enter your password.

Step 9. Once you’re in, look at the left side of the interface and find the search bar. Start typing “Unit Zero” and you will see the corresponding network below. Pin it and click it.

Step 10. On the right side, you will see the information about your tokens within the Unit Zero network. To receive Unit0 tokens to your newly created wallet, click the Deposit button.

Step 11. You will see a QR code and the full address of your wallet, which you can copy and give to someone so that they could send the tokens your way.

Step 12. Now, to send tokens to other wallets, you need to click the Send button.

Step 13. This will open the sending interface. Paste the receiving wallet’s address and specify the amount of token you wish to send.
Note: Here you can also choose the network fee amount, you can leave it at the recommended setting or set it to higher priority by paying a little bit extra.

Step 14. Next, confirm your transaction.

Done! Now you know how to use Unit Zero with Enkrypt.